Hi, @Timot05. I’m a former EE with 20 yrs experience working in the industry and have designed dozens of very large complex mixed signal PCBAs 4-32 layers, as well as about the same number of large FPGA SoC designs.

I watched the demo video out of curiosity and here’s my 2 cents, though there is a lot to unpack here:

First if you want to know the current state of “how does git look like in hardware” as far as PCBA design is concerned look at Altium which uses git under the hood now to provide a very nice visual way to show differences in both the schematic and PCB layout between versions that solves some real pain points for an EE and therefore EEs actually want it and use it. There are ways to create reusable, version controlled sub-circuits that get put into libraries as well:

https://www.altium.com/altium-365/hardware-version-control https://resources.altium.com/p/introduction-git-altium-desig...

Whatever open source you build should be modeled after that.

I found the above very nice after years of manually using git to version control PCBA designs developed in other ECAD tools like PADS, Orcad, Cadence etc. I even tried to get a couple EE’s and layout people to use my methods of git version control, documented in the README of course, but to no avail, most strictly hardware EEs (with no FPGA or SW background) either can’t grasp git or don’t see the point in spending the time on it. The same people will quickly pay $10k-15k a seat for Altium to get that slick UI on top of git version control because it makes things more visual, not less, which as others have mentioned is important in PCBA design I’ll get to in a second.

But, I understand better what you actually mean because you phrased it another way “how can groups of people coordinate and share their work in hardware?”

That depends of course how / who are you coordinating and sharing with? How are you dividing up the work?

In my experience, even with a very large complex mixed signal design, there is one guy per board, and in the extremely rare case that a single board is being worked by more than one person it is usually divided up by discipline typically, RF, analog and digital and those people contribute their pages in any number of ways including using sub-circuit modules out of an Altium library.

And, EEs lean heavily on reference designs and eval hardware to do their work. Though they do spend a lot of time reading a lot of data sheets they really don’t have time to read most of them, just reference the ones they need to integrate existing designs and handle the new parts of the design (which need to be minimal). They need to get large parts of the working designs handed to them with eval hardware they can test and vet on the bench, and with reference designs (schematics, layout, firmware and some documentation) provided by and supported, somewhat, by the vendors of the major components. Not some open source developers who can’t really support the major components utilized in their designs effectively because they don’t have access to all the information they would need to do that, talk to the fab etc. They can only talk to FAEs, same as all other engineers outside the vendor.

Also, PCBA design is very process oriented. Even if a company doesn’t have a PCBA design process this will not slow down an experienced EE who I say has learned what I call “The process” with a capital T. Schematic capture and layout are 2 very hard and fast steps in that process with boundaries that been defined by decades of EE college curriculum and EDA development that aren’t likely to see any change in EE in the near future, though I think the EDA industry is in need of some disruption somewhere, it is not here.

I started designing CPLDs and FPGAs righ...